60%

Sub Woofer 4 ohm 8" Kit Acoustic Research Woofer Cerwin Vega Crossover

Share On:

Original price was: $24.15.Current price is: $14.49.

Meta:
Item Condition : New
gtin13 : Does not apply
Brand : Acoustic Research; CERWIN VEGA
Type : Subwoofer
MPN : UNKNOWN
Model : D01-0011
UPC : Does not apply
Color : kit

Sub Woofer 4 ohm 8″ Kit Acoustic Research Woofer Cerwin Vega Crossover You know for many of us there is no better feeling, than to have built it yourself, the joy that comes from the satisfaction of knowing that you did it right. So who cares if there are a few extra nails, a little missed spot in the corner, this thing is really well built. You tell your buddies…. “HECK YOU CAN DRIVE A TRUCK OVER IT, GO AHEAD, IT WONT BREAK”. You know what I mean, the first one may not be perfect, but you had fun building it, and most of all you learned more than you thought you would by doing it yourself. Well this kit is pretty straight forward, you get an 8″ Dual Voice Coil Sub Woofer, Sub Woofer Crossover, and Port, three little pieces that will bring the bottom back into any home system. You know, you can tailor the box to fit in your Car, and be thumping down the road in no time, it works great there too. “By the Way, one works great, 2 will really pound!!” The kit consists of: One Acoustic Research 8″ Dual Voice Coil Sub-Woofer One Cerwin Vega Sub Woofer Cross Over( Sub crossover point is just above 200 Hz. ) One 3″ Tuned Port Specifications: 8″ Dual Voice Coil Sub Woofer: 4 ohms x 4 ohms 100 Watts RMS 1 1/2″ Voice Coil 25 oz. Magnet Butyl Rubber Surround for Long Cone Travel Response from 35Hz. to 350Hz. Free Air Res.: 32Hz Cabinet Requirements: Works with a cabinet volume of about 1 cubic foot. If you built cabinets with inside dimensions of 12 inches by 12 inches by 12 inches, & if you use 3/4 inch MDF your outside dimensions would be 13.5 inches by 13.5 inches by 13.5 inches, but build to suit you needs, just keep the internal volume to about the 1 cf model and you’ll do fine. *Note that a good material for this project is MDF, you can buy a nice piece of MDF shelving at your local building supply house for about $3.00 in 8 foot lengths (one 8 foot length should be plenty for this box), most have a nice rounded nose for a stylish look. So for about $35.00 you can build one heck of a nice sounding and performing subwoofer. *Building and design note, the output from a sub-woofer is non directional, built to suit your needs, so think outside the box, because placement isn’t critical. Under a table, behind a seat, in a corner, the speaker facingto the bottom, front, top or side firing it doesn’t matter, just place close to a wall which will act as a resonator and improves performance. Remember too, the only thing that you will be getting out of this box are the very low frequency’s, this takes some power to reproduce, so work with at least 40 watts, listening to it by itself is not too impressive, the joy comes from the full chorus of speakers. Please take a look at all of the provided photos before placing your bid to thoroughly inspect the lot contents and condition. Item Condition: New – Pulled from a Factory Sealed Master Carton Return Policy: We are offering the buyer a 30 Day right of return for testing and inspection. Buyer will be responsible for the cost of return shipping. Listed for by – Located at: Shipping weight is 7.00lbs, 0.00oz, shipped from our warehouse in Tennessee. (zip 37370) Default Shipping Service: USPS Ground Advantage Tennessee residents will be charged our local 9.75% sales tax. California residents will be charged our local 10.25% sales tax. ( We have offices in both Tennessee and California and are required to charge tax to any shipment sent anywhere in either state.) B#: