Samger 110 V 90 W Bomba De Refuerzo De Presion De Agua Automatica Con Agua

Specifications: Rated head: 8m Highest Head: 10m Rated capacity: 8L/min Max capacity: 15L/min Maximum speed: 3360r/min Motor rated voltage: 110v Motor max. current: 0.9A Motor wire material: copper Motor power input max.: 90w Motor mains frequency: 60HZ Motor shell material: Stainless steel Impeller & Pump body material: brass Pump interface size: 3/4 (outer diameter 25mm) Installation size, pipe connection: 1″ or with adapter 3/4″ Dimensions of connector and water flow switch: 1/2 (outer diameter 20mm) Installation max. operating pressure: aprox 15psi Installation steps: 1.Please turn off the electricity before installing the pump. 2.Wrap the raw material tape on the water inlet, install the adapter, and use a wrench to tighten the gasket placed in the adapter. 3.Wrap the raw material tape on the water outlet, install the automatic water control switch, and use a wrench to tighten the gasket placed in the screw mouth. 4.Connect the connection line of the water control switch to the pump body equipment (the buckle is fastened to indicate that the connection is successful). 5.Connect the water heater inlet hose to the water control switch of the water pump outlet, and tighten it with a wrench (the hose has a built-in gasket, and the screw is wrapped with raw material tape). 6.Connect the water inlet of the water pump to the water pipe with a hose connection number, and tighten it with a wrench (the hose has a built-in gasket, and the screw is wrapped with raw material tape). 6.Fix the water pump, plug in the power supply, and it can work. Tips: 1.The pump is used on pipes with acceptable water flow and then can start or stop automatically. If there is no or very little water flow, it would not fit. 2.Do not install upside down, to prevent leakage into the interior of the motor, causing a short circuit and burn out the motor. Package Include: 1 x 90w booster pump 👉DURABLE PUMP: Equipped with brass pump head and brass impeller, the water booster pump enhances the long term use and corrosion-resistance, suitable for faucet booster, water heater booster, smart toilet booster, wall-hung boiler booster, shower head booster. 👉AUTOMATIC WATER PUMP: Working with low noise, the whole pump is sealed well and the conveyed water will be clean and sanitary. Intelligent dual control system: Automatic control: Start with water, when you don’t need the water, it would automatically close. Manual control: When the water flow is too small, it can be forced to start. Stop: When you don’t need to use it for a long time, you can set the shutdown protection. 👉WORKING LONGER HOURS: The pressure booster pump is designed to be low temperature, small volumn, delicate appearance and long-working time, effectively solving the lit fire properly of shower owing to the lower pressure and unreliable pressure. The pump is used on pipes with acceptable water flow and then can start or stop automatically. If there is no or very little water flow, it would not fit. 👉EASY TO USE: Small size but having great power to increase domestic water circulating system, perfect for boosting pressure for household water heater. Up to 15psi maximum pressure with booster pump. The diameter of the pump port is 1 inch (25mm), the water flow switch and port are 3/4 inch (20mm), and the thread is metric. 👉DECENT SERVICE: Motor is made of pure copper coil, the pump body is made of stainless iron, and the pump head and impeller are made of pure copper. Your choice of our booster pump is pretty appreciated when ordering today. If you have any other concerns about the installation and usage, please feel free to contact us.