60%

Motenergy ME-1206 Brushless 20HP DC Motor

Share On:

Original price was: $242.00.Current price is: $145.19.

Category:
Meta:
gtin13 : Does not apply
Model : ME 1206
MPN : ME1206
Brand : Motenergy
Seller Notes : “USED”
Compatible Model : Motenergy ME-1206
UPC : Does not apply
Country of Manufacture : China
EV Drives Product Code : MOT-ME1206
Type : Brushless Permanent Magnet Motor

These motors were custom ordered and tested for a few months, then the buyer opted for a different motor. All the motors we ship have been tested and checked for damage. Similar to the ME1117 on the motenergy.com web site. . Mounting and wiring are the same although it uses a Molex Micro-FIt 3.0 8 pin connector. And the shaft is 24mm diameter, not 15mm with a M10x1.5 threaded hole in the end. *BRUSHLESS SINUSODIAL DC MOTORS – BLDC *MUST USE A BRUSHLESS CONTROLLER SEE LIST OF TESTED CONTROLLERS BELOW: *MOTOR WEIGHS (out of box) 22lbs 20oz **SPEC SHEET INFORMATION DIRECT FROM THE MANUFACTURER, IT DOES NOT INCLUDE VOLT AND AMP RATINGS. THE MANUFACTURER GAVE ME THE FOLLOWING INFORMATION: Nominal 50V 100A 5000W 6.7HP – this was the requirements of the project these had been ordered for. These requirements were met by using an existing design: Max continuous 72V 100A 7200W 9.6HP Max intermittent 72V 220A 15840W 21.1HP The motor is capable of running on 96V to get to the 5000 RPM max, BUT, This isn’t recommended. ***ADDITIONAL INFORMATION*** 1) The motor has 8 magnets, 4 pole pairs. 2) The rotor position feedback is a Sine-Cosines sensor made by Renishaw. RMB20AC01SS1. 3) The motor is designed to run at 2500 rpm with a 48 VDC battery pack. A 72 VDC battery pack is 3750 RPM loaded, 12.6 kw peak, 16.8 Hp. 4) Maximum continuous current can be 100 amps with proper air cooling, Rated for 250 amps for 2 minutes. 5) Temperature Sensor is a KTY84-130. 6) Maximum rotor speed is 5000 rpm. If you exceed this speed, then there can be severe damage or personal injury. 7) Winding is 24 turns per Phase, 3-Phase, Y-connected. **FOR MORE DETAILED SPECS, PLEASE REFER TO THIS PAGE: http://www.motenergy.com/me1117.html BRAND: MOTENERGY, USED TO BE MARS BEFORE THAT ETEK Controllers we have tested with these motors: VESC 75200 Version 6.02 firmware supports Sin/Cos encoders. VESC 75350 Version 6.02 firmware supports Sin/Cos encoders. Note: the 75100 doesn’t have enough power to start the motor under load. Power the Sin/Cos sensor on 3.3V for the VESC to read correctly. Kelly Controller 8080N-NPS – this is the only Kelly that supports the Sin/Cos encoder. Roboteq RGBL1860 THIS HAS BEEN TESTED.

Related products