60%

Mitsubishi Crankshaft Pulley Removal Tool 3.0L 6G72 SOHC & 3.8L 6G75 SOHC

Share On:

Original price was: $33.43.Current price is: $20.05.

Category:
Meta:
Manufacturer Part Number : Does Not Apply
Brand : Exeter Products
Country/Region of Manufacture : United States

Please double check the pin spacing and diameter to ensure the tool will fit your pulley, there are a few different pulleys that Mitsubishi used, this tool might not fit. Center to center distance – 3.75″(95mm), pin diameter – .394″(10mm) I’m copying this a 2nd time because people are not double checking the spacing and ordering the tool and the tool not fitting….. Please double check the pin spacing and diameter to ensure the tool will fit your pulley, there are a few different pulleys that Mitsubishi used, this tool might not fit. A simple check with a tape measure will verify that your pin spacing matches this tool. Center to center distance – 3.75″(95mm), pin diameter – .394″(10mm). If your spacing is different, send me a message with the center to center distance and I should have an alternative tool that will fit. If not, I can probably make one. This tool is proudly made in the USA! Developed to aid in the removal and installation of the crank bolt. The bolt is extremely tight and removal is extremely difficult at best This tool allows the factory torque to be attained while preventing the pulley from rotating. This tool should work with the 3.0L 6G72 SOHC & 3.8L 6G75 SOHC pulleys Hole in center of tool – allows access to removal of crank shaft bolt. Offset breaker bar attachment point – simply plug in a 1/2″ drive wrench or breaker bar, and lay against the axle or lower control arm to prevent movement. Low profile design If there is another part or tool that you would like made, let me know & I will see what I can do. I do my best to provide accurate compatibility, there are sometimes anomalies. Feel free to contact me with any questions, I will do my best to help out. If there was an error on my listing and the tool does not work with your application, please first send me a message and explain the problem, I will be sure to correct the issue.

Related products