60%

HV High Voltage Power Supply Kit for PMT Photomultiplier / Geiger tube 1500V max

Share On:

Original price was: $52.75.Current price is: $31.65.

Category:
Meta:
PCB Edition : ver.3b
Brand : Unbranded/Generic
Application : Hobby DIY Projects
Radiation Detector Type : Scintillation Detector
gtin13 : Does not apply
Model : RH-M-PMT-HVPS
UPC : Does not apply
MPN : RH-M-PMT-HVPS
UNI-T Voltmeter on the photos : NOT INCLUDED
Country/Region of Manufacture : Israel
Topology : Boost PWM ~60KHz
Input current : 15mA - 50mA
Based on : TL494
High Voltage output type : Positive HV regulated DC
Type : Radiation Detector
Output Power : 0.2W max
Recommended load for spectroscopy : ~100 Mega Ohm divider
Electrical circuit : NOT INCLUDED
Output Voltage with 100 Meg load : 150V - 1500V
Input Voltage : 12V DC

New 3.0 Revision of Adjustable HVPS DIY High Voltage Module for Photomultiplier Tube 150V – 1500V. This power supply has positive adjustable high voltage output 150V – 1500V (under 10Meg. load) and can be used for DIY Photomultiplier Scintillators, Amateur PMT Projects or for powering Geiger tubes. High Voltage can be adjusted manually with on-board potentiometer or through Digital SPI interface. You need to set the DIP-Switch to select desired controlling method. Example control code for Arduino can be downloaded in Github repository. https://github.com/RH-Electronics/MCP41010T Technical Specifications: Positive Polarity High Voltage stabilized output: 150V-1500V Compatible with DIY Scintillation Probes and Geiger Tubes Digital SPI Control or Manual Potentiometer Control Input DC voltage: 12V Input current consumption : 10mA – 50mA Output power: 0.2W Recommended load of the PMT probe divider: 80-100 Mega ohm Minimum Load: 10Mega ohm Topology: Boost TL494 PWM ~60KHz (easy to filter) Output RC filter included Shipping Weight: 180gr SKU: RH-M-PMT-HVPS This is regulated stabilized HVPS power supply for DIY hobby projects. The module can be used to power several Geiger tubes or PMT tube in gamma scintillation project. Circuit uses PWM high frequency conversion of ~60KHz. It easy to filter the noise because of high conversion frequency. The board of the power supply has installed RC filter to reduce noise factor. 5-Pin connector pinout: GND – for external microcontroller ground reference 5V OUT – allows to power external low profile microcontroller SDI – SPI data input SCK – SPI clock input CS – SPI Chip Select, Active -HIGH DIP-Switch Selector: You must set just one of the illustrated dip-switch pre-sets. DIGITAL: 1-ON ; 2-ON; 3-ON; 4-OFF; 5-OFF; 6-OFF MANUAL: 1-OFF ; 2-OFF; 3-OFF; 4-ON; 5-ON; 6-ON By default, shipped with MANUAL pre-set. Recommended to be purchased with our Pulse Amplifier: https://www.ebay.com/itm/322575299576 HV is DANGEROUS! You are fully responsible for any technical damage or health injury caused by this electronic device. We’ll use the best shipping method available to your destination, however some areas and some countries now will take much longer to receive international mail. Please allow longer delivery time than usually and contact me prior buying if you want to change delivery method.

Related products