60%

Fuji GX617 Replacement Hood for 180mm, 3D Printed

Share On:

Original price was: $30.80.Current price is: $18.48.

Category:
Meta:
Type : Square
Brand : Fuji

I own (and LOVE) the GX617 camera. Recently a friend of mine got ahold of one but did not have the hood. I modeled this aftermarket hood off of the spec of my own hood. Printed in black matte PETG (printed as 2 separate pieces, then bonded together) with a threaded insert for the tightening screw. The OEM tightening screw is a very specialized (knurled thumb screw with another threaded hole bored into the threaded end to screw on a small rubber bumper). Instead, this design relies on an M3 nylon screw which should not cause your lens barrel any damage provided you’re careful not to screw down exorbitantly tightly. I will include an additional thumb screw. Please reach out if you have any questions. Cheers! This hood is for the 180mm lens (which has a 77mm filter size). Part may vary slightly, from picture as these are all hand assembled. If you have any concerns, just contact me.

Related products